Loading...
635-800A · 600 Series · Penta Series
This module will control NTP Audio Routers that support DOT Protocol.
Requires Companion 5.1 or later.
Enter the IP address of the control port of the router controller. The default port is 10005.
In the case of redundant router controllers, enter the secondary controller IP and port, and enable the redundant controllers' switch. When the module is enabled it connects to the Primary. Whenever a connection fails or closes, the next attempt, 2 seconds later, is to the other controller. An attempt that has not connected within 5 seconds counts as failed.
Configure the Source and Destination count, this should be equal to highest index number used for each. The system will limit values entered to the specified range. Refer to the VMC-Config app, Configure>Logical Lines to identify Index values.
The alarms should match the number of configured alarm indexes in your system. Refer to VMC-Config, Configure>Messages. You can edit each entry and check/set the Number field to set the Alarm index.
The module requests alive notifications every 60 seconds as a keepalive. A router that has answered one, and then does not answer the next within 10 seconds, is taken to have gone, and the module reconnects: to the other controller, if redundant.
Crosspoint Set, Remove or Interrogate a crosspoint
Input - Delay Set input delay
Input - Gain Set input gain
Input - P48 Set input phantom power
Destinations, sources and gain are chosen from a list, or with an expression. An expression must return a destination number from 1 to the destination count, a source number from 1 to the source count, or a gain step from 0 to 7. For Crosspoint the source may also be 0, for no source. Anything else and the action is not run.
Each message waits for a reply from the router, for up to a second, before the next is sent. Button presses are sent ahead of the interrogations made for feedbacks.
Messages still waiting to be sent are merged. A destination asked for more than once is interrogated once, and several settings of one crosspoint, or of one input's gain, phantom power or delay, go as one, with the last value chosen, in the place of the first.
unknown until the router reports itThe Action Recorder will translate any crosspoint notifications into new crosspoint actions, to quickly build salvos. Other actions are not supported.