Loading...
EM2 · EM2 Dante · EM4 · CHG70N · CHG70N-C
Because of large changes inside the Companion application you need to replace existing buttons with the new presets to get the status displays working again!
Just select the device from the module config window and enter the control IP of your EM2/EM4 receiver or network charger and press 'Save'. To control multiple devices, just add the connection several times to your Companion instance. For receivers with firmware >= 4.0.0 : please enable the "Legacy Mode" in the Sennheiser WSM Software for the receiver, to be able to control the devices using the SCP v1 protocol. If this is not done, you can't control your devices via Companion at this point.
This module stores pretty much all information the connected devices provide - some of them are available as feedbacks - but not all of them! So make sure to explore the "Variables" tab in Companion, to get an overview about all available information (e.g. Mounted Capsule on SKM, Battery charging cycles, transmitter type, etc.)
The channel status presets use Companion 5's native drawing layers and standard font. The battery label sits inside the battery, the channel name and frequency have their own text regions, and the mute and warning icons occupy separate footer slots. The canvas decoration is set to None, so the antenna indicators reach the top edge without reserving space for the top bar.
After updating from the legacy status display, apply the Channel Status preset again. Existing buttons retain their original layers; module upgrade scripts cannot replace those layers. The legacy RX: Status Display feedback remains available for existing buttons.
In the module presets you will find a status display for every receiver channel of your device. It contains the following information:
H:MMh (for example, 312 minutes is 5:12h)Beside this information the following icons are used:
AF Peak
Warning - one or more warnings are currently present on the receiver channel
Encryption - Disabled
Encryption - Enabled
Encryption - Error (for example because Encryption was disabled and enabled again without syncing the transmitters again)
Muted - Either the transmitter or receiver is muted
RSQI - Good signal (> 70%)
RSQI - Medium signal (> 40%)
RSQI - Bad signal (>= 1%)
RSQI - No signal / No RSQI information (0%)
Antenna - A is currently receiving
Antenna - B is currently receiving
Battery - Shows the remaining battery percentage (> 50% Green, >= 20% Yellow, < 20% Red)
When the RX identification is active (either by triggering from Companion or by pressing the Power Button on a transmitter), a green bar at the bottom of the button is shown. If you are using the preset, the identify action will be already assigned to the button.
The Bay Status presets use native Companion layers, with the percentage inside the colored battery, separate device and charging-time text, and dedicated warning icon slots. After updating, apply the preset again to replace existing legacy buttons. The old Charging Bay: Status Display feedback uses deprecated image buffers and is retained only for existing buttons.
In the module presets you will find a status display for every charging bay of your device. It contains the following information:
Beside this information the following icons are used:
Warning - one or more warnings are currently present on the charging bay
Charging Error - The battery can either not get charged or discharged
Communication Error - The charger can't communicate with the battery
Temperature Error - The battery temperature is outside of the supported range (either too cold or too hot)
Overcurrent Error - An overcurrent was detected
Bay State: normal
Bay State: not normal - the current bay state is either UPDATE, ERROR, or DFU_MODE
When the bay identification is active, a green bar at the bottom of the button is shown. If you are using the preset, the identify action will be already assigned to the button.